更多訊息請參考每個模型版本內的 About this Version.
For information about each version of the model, please refer to About this Version for each model version.
各モデルのバージョンについては、各モデルのバージョンについてを参照してください。
각 모델 버전에 대한 자세한 내용은 각 모델 버전에 대한 이 버전 정보를 참조하세요.
Issues
推薦使用 DPM++ 2M/3M Karras 採樣器。
The DPM++ 2M/3M Karras sampler is recommended.
サンプラーはDPM++ 2M/3M Karras シリーズを推奨。
DPM++ 2M/3M Karras 시리즈 샘플러를 권장합니다.
Recommend Negative Prompt
(worst quality, low quality, normal quality), disabled body, (ugly), sketches, (manicure:1.2), lowres, watermark,Description
由 v6.0 版本透過特製 Lora 調整了以下項目：
光源表現較為明亮
增加背景變化
細節增加
The following items have been adjusted from the v6.0 version through the specially designed Lora:
The light source appears brighter
Add background variation
Increased detail
特別に設計された Lora により、v6.0 バージョンから以下の項目が調整されました:
光源がより明るく見える
背景のバリエーションを追加
ディテールが増加
특별히 디자인된 Lora를 통해 v6.0 버전에서 다음 항목이 조정되었습니다.
광원이 더 밝게 보입니다.
배경 변형 추가
세부 정보 증가
FAQ
Comments (4)
good potential, but too hard to work with ipadapter and instantID (snowflake artefact in low cfg setting, bad generation and oversaturation in 5-8 cfg setting). will revisit later when i'm done playing with ipadapter/instantID
Try the Apply InstantID Advance node, use the "noise" to helps reducing the "burn" effect.
You're not supposed to have CFG that high for Lightning-like models. All the examples in the header are, like, 1 and 1.5. That's how you get these cartoonish results, usually.
@Vospi yes, finally i understand how step and cfg relation, also how it interact with different sampler and scheduler. Been experimenting with dmd2 lora for a while now in cfg 1. i'm downloading these models again and see if i can produce better result.
Details
Available On (1 platform)
Same model published on other platforms. May have additional downloads or version variants.