Just wanted to tweak a bit the view angle. The LECO ended up quite gentle and linear. I could train it further but i don't normally do big adjustment in the view angle, so I am fine with the granularity. If you wish to start higher or lower you can use From_Above and From_Below and do fine adjustments with the LECO.
For me it was stable from -5 to 5 I didn't have time to check further.
Until the XYZ plot was finished did i finally realize that i am dumb and you can't have a from_below angle for the on_back position because you would be inside the bed. :P
LECOs are manipulated by their weight and normally need no triggers to use it, change their weight like this <lora:AboveBelowView:-1> to lower the "camera" <lora:AboveBelowView:1> to Rise the camera. Remember you can go further than -1 or 1!
Description
LECO
FAQ
Comments (7)
Works! Immensely useful, thanks 👍
i'm testing it right now, the LORA file name is different from what the description is given. let me know how you get it to work well.
@zhe20 Civitai renames stuff, just change AboveBelowView for the changed filename. <lora:AboveBelowView:-1> like this <lora:changedname:-1>. If you are using the civit generator, I think you can simply erase it and directly control the strength with the slider. Above 0 changes the angle to from_above, below 0 changes it to from_below. As this is a leco it doesn't require triggers just change the weight.
thanks, after initial testing, it definitely works. i still can't get the camra angle i want, but it's one step closer. might get it right with this LORA and some fine tuning.
For XL pls <3
Sorry, my videocard is too crappy for SDXL training
Work well! Thank you!